Garage door won't close: sensor repair in Ridgewood

A garage door that refuses to close is annoying, but it is the safety system doing its job.

Call (551) 250-5840

In short

If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Ridgewood realigns or replaces the sensors and tests the safety reverse.

Wi-Fi garage door opener mounted on the ceiling

Doors that won't close in Ridgewood

More than a third of Ridgewood's houses were built before 1939, and many have a detached garage at the end of a long driveway. In Upper Ridgewood and around downtown, those garages are damp and little used, so cobwebs and corrosion build up on the sensors between visits. In The View and Salem Ridge, sloped lots carry leaves and water to the door. In Ridgewood West, Floral Park and Brookside, narrow garages put the sensors within reach of every bumper. The village's street trees make November the busiest month for doors that will not stay down.

Why a garage door refuses to close

  • Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
  • Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
  • Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
  • Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.

What you can safely try yourself

Clear the doorway, clean both sensor lenses, and check that the two sensors point at each other at the same height. A steady light on each side means they can see each other. If one keeps blinking after that, or the wires look damaged, leave it for the technician.

Never disconnect the sensors or move them up out of the doorway to get the door working. They are what stops the door from closing on a child, a pet or a car.

Fixing it properly

Most of these visits are short. Sensors are realigned or replaced as a matched pair, damaged wire is rerun and secured, and the opener's travel and force are set for your door. If the opener is old enough that it has no working safety reverse at all, the technician will say so and explain the options, and nothing is replaced without your say-so.

Around Ridgewood

  • Ridgewood West: A neighborhood where most homes date to 1939 or earlier, with detached garages.
  • Floral Park and Brookside: Residential streets near downtown with older homes and narrow driveways.

See the full Ridgewood service area.

Door stuck? Call before you try to force it.

A door with a broken spring or cable can drop suddenly. Leave it closed, keep clear, and call. We'll tell you whether it's safe to use and get a technician scheduled.

Call (551) 250-5840
Call (551) 250-5840